ClareControls CH-THSTAT-W Guide de l'utilisateur télécharger pdf (Page 28)

20 Clare Controls IP Network Camera User Guide

IP property settings for wireless network connection

The default IP address of the wireless network interface controller is 192.168.1.64.

When you connect the wireless network you can change the default IP.

To change the default IP:

1. Enter the TCP/IP configuration interface.

Configuration > Camera Configuration > Network > TCP/IP

2. Set Select NIC as wlan.

3. Customize the IPv4 address, the IPv4 Subnet Mask, the IPv4 Default Gateway, and

the Multicast Address.

The setting use the same process as the LAN.

If you do not want to assign the IP address, select the checkbox to enable the DHCP.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Clare Controls IP Network 1
Cameras User Guide 1
Disclaimer statement 4
Content 5
Important information 9
Safety warnings and cautions 10
Advisory messages 11
System requirement 12
Network connection 13
Figure 3: SADP interface 14
Static IP connection 15
Dynamic IP connection 16
Access to the network camera 18
5. Click OK 19
6. Click Next 19
7. Click Finish 20
Wi-Fi settings 21
Security mode 23
EAP-TLS or EAP-PEAP 24
PBC mode: 26
PIN mode: 26
Live View 29
Starting live view 30
Full-screen mode 30
Operating PTZ control 31
PTZ control panel 31
Setting/calling a preset 32
Network camera configuration 34
Configuring time settings 35
36
Configuring TCP/IP settings 37
Configuring port settings 38
Configuring PPPoE settings 38
Configuring DDNS settings 39
Configuring SNMP settings 41
Configuring 802.1X settings 42
Configuring QoS settings 43
Configuring FTP settings 43
Configuring UPnP settings 44
Configuring video settings 45
Configuring audio settings 47
Configuring ROI encoding 48
Configuring image parameters 48
Configuring display settings 48
Configuring OSD Settings 51
Configuring privacy mask 53
Configuring picture overlay 54
Configuring motion detection 55
Handling exception 58
Uploading to FTP 60
Configuring other alarms 61
Configuring PTZ 63
4. Click Save 68
Clearing a PTZ configuration 69
Storage settings 70
Playback 75
Log searching 77
Streaming video types 78
Managing user accounts 79
Anonymous visit 81
IP address filter 82
Viewing device information 84
Maintenance 84
Rebooting the camera 84
Restoring default settings 85
Upgrading the system 86
RS-232 settings 86
RS-485 settings 87
Appendix 1 88
Modify network parameters 89
Appendix 2 90

Commentaires sur ces manuels

Pas de commentaire

ClareControls CH-THSTAT-W Guide de l'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Thermostats ClareControls CH-THSTAT-W